All articles

R2 Trigger Reset Written Instructions (GT)Updated 2 years ago

Accessing the trigger reset screen

  • Ensure the board is OFF and the remote is ON.
  • Double-click the 'ON/OFF' button to enter the menu.
  • Scroll down to 'More Info' using the 'DOWN/MODE2' button.
  • Click the 'ON/OFF' button again to enter 'More Info'.  
  • With the screen showing Product ID, double-click the 'ON/OFF' button, followed by quadruple-clicking the 'DOWN/MODE2' button (four clicks of the 'DOWN/MODE2' button in total).
  • The screen will now show the trigger page.


Setting the trigger values

  • Ensure 'Change ACC Pol' is shown as a minus symbol (-). Click the 'ON/OFF' once to change if it is a plus symbol (+).
  • Click 'DOWN/MODE2' to highlight 'Set Acc Min' in red. Pull the accelerator trigger all the way in, and whilst holding, click the 'ON/OFF' button to set the Acc Min. 
  • Release the accelerator trigger.
  • With 'Set Acc Max' highlighted, inspect the 'Acc Trigger' value at the top of the screen. Pull the accelerator in slightly so that the value is around 100 below the resting position. Whilst holding, click the 'ON/OFF' button.
  • Release the accelerator trigger.
  • Ensure 'Change Brake Pol' is shown as a plus symbol (+). Click the 'ON/OFF' once to change if it is a minus symbol (-).
  • Click 'DOWN/MODE2' to highlight 'Set Brake Min' in red. Inspect the 'Brake Trigger' value at the top of the screen. Push the brake in slightly so that the value is around 100-150 below the resting position. Whilst holding, click the 'ON/OFF' button.
  • With 'Set Brake Max' highlighted in red, push the brake trigger all the way in and click the 'ON/OFF' button again.
  • The ‘Return’ line should now be highlighted.
  • Click the 'ON/OFF' button once to exit the trigger screen.
  • Turn the remote off.
  • Turn on the board. 
  • Turn on the remote.
  • Pair the board and remote, if it does not do this automatically, press and hold the 'UP/MODE 1' button until the Wi-Fi symbol on the remote begins to flash.

Test if your concern persist.

If it does, please send a photo of the trigger screen and any additional details to your local tech support team.

Was this article helpful?
Yes
No