All articles

🔁 Phaze Stuck in Calibration Loop with Fast Red Flashing Lights? Here’s What to DoUpdated 9 days ago

If your Phaze remote connects to your board but gets stuck in the calibration screen — and your board shows rapid red flashing lights — this usually means there’s an issue with the brake trigger sensor.

This type of internal fault can prevent the remote from completing calibration, making it unusable until repaired.


What This Means:

  • Your brake sensor is likely damaged or misreading input.

  • The remote will not exit the calibration mode on its own.

  • The board flashes red rapidly because it’s receiving constant (false) brake input.


Was this article helpful?
Yes
No